MODRATEC Useful Data (otherwise known as MUD) is a series of pages containing helpful information particularly relevant to rail modellers. This page is an index to our tapping drill tables.

®

Printer-friendly

Tapping Drill Sizes

The tables accessible from this page cover both imperial and metric threads commonly available.

Rather than specifying a specific drill size for each thread, a range of sizes is indicated. Using a drill towards the minimum size will result in a stronger fit (fuller thread depth), while the maximum size produces a weaker fit (approximately 50% thread depth).

For general modelling purposes, any drill (imperial, number or metric) falling within the range will be satisfactory although it is better to be closer to the minimum than the maximum for a reasonable depth of thread. Avoid using the exact minimum except in an emergency as this may give rise to excessive strain on the tap.

Hint: A "rule of thumb" calculation worth remembering is:

Tapping Drill Size = Screw Diameter - Thread Pitch.

Revised and extended 09-Nov-2003

• BA - British Association
• BSF - British Standard Fine
• BSW - British Standard Whitworth
• Metric Coarse
• Metric Fine
• ME - Model Engineer
• UNC - Unified National Coarse
• UNF - Unified National Fine

^Top

For affordable and effective Web Hosting, MODRATEC uses and recommends Hosting Bay

I put the frame in for the club modelling competition and received a lot of favourable comment from members.... (Archie)